Red error screens are designed to stop incorrect data from entering the system. If you encounter one, find the matching error message below to resolve the issue.
These errors occur when scanning the CC-Link hardware. "Unit already associated with another vehicle" The Issue: This CC-Link is already registered to a different VIN.
1. Unit Identification Errors
The Issue: This CC-Link is already registered to a different VIN.
The Solution:
Confirm you have scanned the correct unit.
If the unit is being reused, it must first be decommissioned from the old vehicle in ConnectedWorkshop.
If the unit is brand new, contact Support as it may have been incorrectly registered at the factory.
"CC-Link is not valid for registration"
The Issue: The serial number or prefix is not recognised in our database.
The Solution:
Enter the serial number manually to ensure the camera hasn't misread a digit.
If manual entry fails, the hardware version may be unsupported. Please set the unit aside and try another.
System Message: "No CC-Link is needed in this vehicle"
Issue: When entering a VIN during vehicle setup, a red-bordered notification appears stating: "No CC-Link is needed in this vehicle. This vehicle is already equipped with factory connectivity hardware, so no additional installation is required."
Solution
Do not install hardware: Skip the physical CC-Link installation completely.
Finish the setup: Fill in any remaining details (like the vehicle model and workshop).
Create and Activate the vehicle: Save the profile and proceed directly to activating the vehicle in ConnectedWorkshop and inviting the customer.
2. Vehicle Identification Errors
These errors occur when scanning the VIN or Number Plate.
"We couldn’t read the VIN from the photo"
The Issue: The app cannot identify the characters due to glare, low light, or dirt.
The Solution:
Wipe the VIN plate and ensure there is no reflection from your camera flash.
If it fails again, select 'Enter manually'.
"This vehicle can't be registered"
The Issue: The VIN format is incorrect or the vehicle model is not yet supported.
The Solution:
Verify the VIN against the vehicle’s logbook or physical chassis stamp.
Check for common errors: ensure you haven't swapped the number '0' for the letter 'O', or the number '1' for the letter 'I'.
3. Connectivity & Permissions Errors
These errors occur during account verification or the "Heartbeat" test.
"We couldn't verify this email address"
The Issue: Your email is not recognised as an authorised technician for this workshop.
The Solution:
Check for typos in your email address.
Ensure you have accepted your invite to the workshop as a Workshop or Organisational user.
Ask your Manager to verify your account status in the 'User Management' tab.
"Not connected: Unit has not communicated back"
The Issue: The unit is powered but hasn't sent a signal to our servers.
The Solution:
Check Power: Ensure the ignition is ON.
Check Signal: If you are in a basement or metal building, move the vehicle closer to an exit.
Wait: Data connection can take up to 3 minutes.
Last Resort: Select 'Skip without connecting'. The vehicle will remain 'Offline' until it is driven into an area with better mobile signal:
4. Final Validation Errors
"Licence plate is invalid"
The Issue: The plate does not match regional formatting (e.g. too many characters).
The Solution:
Manually edit the plate info.
Remove any extra spaces or special characters.
Still stuck?
If the screen remains red, please take a screenshot of the error and select the 'Contact Support' button at the bottom of your screen to send it to our team.